help with an expiriment

[Cha0tic]

ok, i am testing the effects of molding your paddles in your 12v revvy so that they do not hit the side of the revvy. this can be done by heating them and then bending the paddles up.

anyways, i loaded my hopper up with about 200 balls. i turned the revvy on and then let the balls fall out for exactly 10 seconds. i did this expiriment 3 times and concluded that i was feeding an average of 13.6bps.

can someone repeat this expriment with an unmodded revvy? i would like to know the differenced between revvies that have the paddles folded up off the side and stock revvies.

[Army]

Instead of bending the paddles, which would now be in a better position to "catch" a ball and break it in the hopper, I sanded about 1/2" of the tip to be very thin and pliable. As it now contacts the sides of the hopper, it easily bends without slowing the motor yet still pushes balls around as well as before.

[PyRo]

Just spend $140 on a halo

[Restola]

anyone see where i left my bottomless wallet?

[Cha0tic]

lol rest...

can anyone help me out here? it will take like 2 minutes to do.