Loader for RT Pro?

[dolphin1823]

Do I really need to go with a force feed loader?

I know with the Revi, there is delay with the agitating since it needs to wait for a gap to spin, and I seem to remember not having this problem when I had my Ricochet loader years ago, but that agitated per every trigger pull.

Any advice is appreciated
Thanks

[Shirow]

Was the loader upright? If so, 3 shot bursts are unlikely to be quick enough to require a force feed in my experience. If you were tilting it, it can happen.

Try a warp

[athomas]

You can intelli-feed the revy. It will make a faster response to the shots being fired.

I suspect the fast action of the retro valve combined with a low neck and possibly a slightly tilted gun angle are causing your pinch issues. Even an intellifeed activation won't even help if this is what is happening. Any gravity fed system will suffer from the same problems, even the Egg and the Richochet. The only solution may be to get a force fed hopper.

The powerfed bodies did not suffer the same fate. The blowback air bounced the next ball into the chamber faster than it could fall by gravity.

[vf-xx]

I've always found that the 6-arm impeller upgrade did wonders for my revvy. Helps alot on minior tilts.

[Ando]

Try cleaning up your detentes too. I've had issues like that due to sticky detentes

[Newt]

I've never had an issue with my old(ish) Halo. They can be had very reasonably now.

That Dye Rotor is high on my wish list though. Very slick system, it makes my Halo look like my Tippmann 98 does when I set my mag next to it.

[XmaverickX]

I use a Ricocet AK and have never had that problem. I have also used the Revvy w/X Board though, and still no problems. Was the battery low in your loader?