Well, Im having one hell of a time trying to remove the tank part of my Armageddon. A few weeks ago when I was working on taking it off the tank I ended up twisting & later snapping a piece of 11mm hex alum. Yes I had my wife's hair dryer to help try & loosen the thread locking compound (put that since Im still not sure what was used). After that I gave up for the night. Well, a few day later when I was checking something I noticed that I did rotate it about 45*. About an hour ago I said, "what the hell, I will try again." Im back to the same place minus the broke stuff.
I also drew a tool thingy that would slide over the reg & have 4 solid 1/8npt dowels threaded into the reg & a 2" wrench to twist with. I will get the pic up when I find it.
Any suggestions?
EDIT: Found the pic.
at its thinnest part, its still .375" front/back & .298" on the sides. 1" thick & 2" wrench flat to flat.
I also drew a tool thingy that would slide over the reg & have 4 solid 1/8npt dowels threaded into the reg & a 2" wrench to twist with. I will get the pic up when I find it.
Any suggestions?
EDIT: Found the pic.
at its thinnest part, its still .375" front/back & .298" on the sides. 1" thick & 2" wrench flat to flat.