X-Valve Shoot Down

[Carnage reigns]

So I finally got my r/t to work after I installed my viperblade . But it seems to have some shootdown. Balls were just rolling out the barrel. I was wondering could somebody help me with this. I don't hear any leaks .

X-Valve w/ ULT w/ 6 shims
CP 45/4500 Tank

[xero28]

Might be an issue with the ULT? I would suggest trying to put in an RT on/off if you have one and see if you get the same problems. If not, try adjusting the amount of shims in the ULT. That's all I've got for now. Good luck.

[Spider-TW]

Do you have good pin engagement on your ASA (does your ASA depress the pin far enough on your bottle)?

[Ando]

Humor me and tighten up your field strip screw with a allen key. Snug it down 1/3 turn pass finger tight. Then try firing it.

If that doesn't work, try redoing your lvl 10

[Carnage reigns]

I have a CP ASA so it's adjustable and I have done so. The ULT was tuned by the factory but I will try that. I do not have an R/T on/off. The Field Screw is screwed very tight.

[SSP REAPER]

I have a CP ASA so it's adjustable and I have done so. The ULT was tuned by the factory but I will try that. I do not have an R/T on/off. The Field Screw is screwed very tight.

try taking it out and reinstalling it finger tighte then a 1/4 turn more with an allen key. try that and let us know how it goes! It may be too tight...

[ZapTheMad]

"very tight" is usually not good. You should not need to tighten it with tools. I bet it will shoot fine if you loosen it up and screw it down finger tight.

[Ando]

If you have after market parts (body and rail are the main ones) they sometimes have clearance issues. reason why we're telling you to tighten down your fieldstrip screw a little more with a allen key.

Edit: If all your parts are AGD then what Zap said is spot on.

[Carnage reigns]

Yeah I have a shadow rail

[Ando]

Do you get like 3-4 good shots then it starts burping and then can't shoot it anymore?

[Carnage reigns]

yeah, that's exactly what happens

[AJoe]

My x was doing that too, 3-4 shots quick and it would burp out a few at low velocity or barely at all. Than it would shoot one at full fps and the ball would collide in the barrel or in the air. I tried every thing, it was very frustrating, ended up getting a new reg for my bottle and all was well. Just my story.

[Ando]

yeah, that's exactly what happens

Stick something down the barrel and see if you can reset the bolt by pushing it

[flyingpootang]

Are you using a high output tank?

[Carnage reigns]

Yeah I can then it acts like no air is going to the valve. I'll shoot 4 good shots, the valve will reset and for some reason I still can't shoot.