Pump Mag Problem...

[Kraniumkrash]

By "dropped a bushing in" I meant there was none "inside" the wave spring before I dropped it there... Lame, I know.

[Rudz]

That's called a "bumper" make sure it sits inside the inner diameter of the wave spring, sometimes you have to cut the bumper to fit, depending on where you got it.

A "bushing" is the piece that goes into the bottom of your rail in the rear to hold the frame/ rail in alignment

[Kraniumkrash]

And I stand corrected! hehe I'll update this after I have time to tinker with it a little.

Thanks to all again!

[pump]

my friends PMag had the same problem
it was the rail to frame spacer/bushing/tube that goes around the valve screw

a longer wave spring would of fixed it, but i cant get one longer here