Valve acting up

[ThaBobsta]

Hey Guys,

I am running an emag valve with the lvl 10, I have finally taken the liberty to take it all apart and learn exactly what is happening when I fire it. However I was playing over the weekend and I could stop chopping. So I go to inspect the powertube(I think) and the carriers/spacers and I can't for the life of me get it out! Any tips on what I should be doing, aswell does the AGD store accept paypal, or any store that isn't out of stock on the carriers/spacers that take paypal that you guys know of?

[Smoothice]

what are you trying to do to get it out?

I have to use a dentist pik to pull everything out. It does not just fall out when turned upside down.

[ThaBobsta]

oh, lol okay I had been trying to tap the valve, as I saw in a video a guy did it and it came out nice and smoothly. Thanks.

[TwilightG]

If you carefully thread the field strip screw down the powertube after removing the tip (dont want to ruin a carrier o-ring), you can usually pull the carrier and shims right out.
The washer will just fall out from tapping the valve at that point.

[Ando]

What TwilightG said...

Bagging the valve on the table only works with the normal internals (none Lvl 10). To get the Lvl 10 carrier out with 0 damage to your oring, use your field strip screw. Softly insert it into the powertube till you feel it bottom out. Apply a little pressure and give it half a turn then pull out. You should have your carrier on the tip of your field strip screw. If you don't succeed the first time try try again till you get it right. 100% the best and safest way to get it out.

[Smoothice]

hmm. I'll have to give that a try.