On one of my mags that I have polished up, I wanted to put braided steel lines. In order to make it easier, I wanted to use swivel fittings, but when I got it hooked up, 2 out of the 4 fittings were leaking. The fittings were made by 32 degree and actually came in a Mag Upgrade kit that I got so I figured they should be able to handle the pressure. Bad fittings, or are they not made to be used on higher PSI markers? One of the fittings you can tell, it literally pushed the seal out.
-
32 degrees makes the worst crap on the market. I wouldn't even use their stickers.
Kapp made some swivel fittings that weren't too bad. I have used those in the past. -
I second that on the 32 Degrees stuff. I had a 32 Degrees mag oring kit. I ended up throwing all the orings out after I discovered that they introduced more problems than they solved. I just couldn't trust them to work. It wasn't worth it.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
-
-
Yeah, I have some black ones that keep blowing out.
I think mine were Extreme Rage or Omega or somesuch.
If you find good colored swivels let me know.
My chrome ones seem to last just fine though.
-- Feedback--Comment
-
I am looking for chrome ones. Found a site that sells them, but doesn't give a brand. I have some blue ones sitting around here, but they are the same 32 degree ones.Comment
Comment