It's been a little bit...

[DeuceSV]

With my karta body and rail, If I'm going to replace the Emag lowers with say a Y-frame or an intelli, what length on/off pin do I need?

My xvalve currently has a ULT in it... would that work?

Thanks,
Jason

[Frizzle Fry]

With my karta body and rail, If I'm going to replace the Emag lowers with say a Y-frame or an intelli, what length on/off pin do I need?

My xvalve currently has a ULT in it... would that work?

Thanks,
Jason

You were running emag lowers with a ULT

[MANN]

yes it would work. if you want an rt on/off you need .750" long

[DeuceSV]

no no no. ULT was not with the lowers haha that would be disastrous!

But thanks for the help!

[DeuceSV]

One more thing... If I replace the Emag lowers with a Z-frame, does the type of sear I need change?

Thanks!

[MANN]

emag lowers have an emag sear that is installed with them. people usually include this when selling their lowers as the sear is useless in other frames. You will need an RT or am/mm sear depending on what rail you use.

[DeuceSV]

okay thanks, got it all covered then!

what happened was I picked up the whole karta emag without an X-valve because I had one... but I never played with it, because I want to lose the lowers and replace it with a Z-grip.

Just hard to find them when you don't have anything but trade items these days.