e-mag question

[teichild]

hi all. i see alot of very smart people on this forum and want to ask a question about some parts i bought recently.

i have a karta body with matching karta rail ( from an e-mag ), an x-valve with lvl 10 superbolt, and i just bought a e-mag lower for it.

now the question is, will this all go together and work properly? i was roaming around the forums here and see that some people are haveing problems getting their x-valve to work with an e-mag trigger frame. something about the "pin" not being short enough or something to that effect. i also noticed that people are talking about a on/off switch on the valve i think for an e-mag. it could just be that im ignoraint but i dont see an on/off on my x-valve. my X came from an RT pro that i have been slowly upgradeing to the point now that its basicly a whole new gun.

i figure this would be a good place to ask this even though most of you will think im a noob. any insight would be greatly appreciated.

[Tunaman]

Your Xvalve probably has a standard on/off...which is what you want...NOT a ULT. You will need the .712 pin and quad oring to make the emag work right. I have them if you need them. Email [email protected]

[maniacmechanic]

Evidently you bought the X valve off Fiery
Tuna is allways right
You forgot THE PICS

[teichild]

fast response. Im gonna go with tunas advice, no offence fiery, just seems like tuna is the athority on everything mag. and i would post some pics but i broke my camera last month and havnt replaced it yet.

thanx again guys

[Ando]

Biggest things about lowers is they traded hands regularly and people adj them to run different setups. I'm guilty of it myself, I've adj my main E-mag to run a ULT for mech mode. When people do that though, standard setups like a normal on/off with the .712 pin won't work with it anymore and you'll have to adj everything back to nominal.

We can talk you through the adjustments which is or you could send it off to a tech (ADG or Tuna) and they'll get it running for you without a 3 page thread

If the person you purchased the lowers was running a standard on/off, you shouldn't have any worries. If you do run into a problem, the forums is the best place to get the information you need.

[teichild]

im gonna purchase a new pin and 4 oring setup from tuna and see if i cant get it rockin myself. hopefuly it works out, if not maybe ill see if tuna would take a look at it if he has time. thanx for the info.

[fierymartel]

Ouch! That hurt. Again, take it or leave it. Not at all an expert or even close. I believe I've even included a disclosure. No, he didn't buy the valve from me.

[maniacmechanic]

Ouch! That hurt. Again, take it or leave it. Not at all an expert or even close. I believe I've even included a disclosure. No, he didn't buy the valve from me.

No disrespect , it sounded like you knew the valve he had , had a ULT in it , I assumed he bought it from you ( I was wrong )
Like Ando said running a ULT in a E Mag is very techy , it take a lot of expermenting to get one to run right

[fierymartel]

Nope, I'm a Noob! LOL, I thought xvalves came with the ULT. That sucks if they don't cause I think I'm gonna need one for my Hyperframe.