Emag board microswitch

[rythm68]

So while cleaning the entire gun I managed to break the small white tab off of the surface mount microswitch on the control board while reinserting the board back into the frame. Anyone know where I can find one or two? Thanks.

[Tunaman]

I have them. Email [email protected]

[flyingpootang]

Just a quick note when you get a new one from Tuna, you can pry off the cover and replace the tab. instead of trying to re soldering it..

[Tunaman]

Just a quick note when you get a new one from Tuna, you can pry off the cover and replace the tab. instead of trying to re soldering it..

Not always possible. Different manufacturers make these switches. They may not be identical to the original AGD switches from 2000. I suggest soldering on the new switch.

[rythm68]

Tearing apart a micro component is not a good idea. You just increase the risk of loosing or damaging internal parts.

[KC]

Tearing apart a micro component is not a good idea. You just increase the risk of loosing or damaging internal parts.

I have also had great success replacing them the way flyingpootang suggested.

/No disrespect intended Tuna.