Ok I have a slight problem and hope you can help me out. I have a S070C-SDG-32 noid in my E/P mag. After I got everything installed and put air on it I noticed that the ram had pressure on it and thus it is applying pressure on the sear. With that said my mag will only fire on trigger release, not on trigger pull. What did I do wrong?
-
-
Crazy guess, swap your wires around.
What setup do you have? -
I tried to swap the wires before posting this. I have it connected to a 2 botton open bolt t-board.Comment
-
My guess is that you didnt wire your micro switch for a NO (Normally Open) circuit.
Please go here and look at the wire diagram of the switch in the upper right corner. The switch on the right is the one you need to wire it as.
The one on the left is not the one you want.
~ P8nt
_______________________
Jai "P8ntbal4me" MenardComment
-
Originally posted by pbjunky99
FYI: The 2-button Open Bolt UTB is the same as the 1-button Open Bolt UTB (the same meaning the board and board software)
The board you order just comes with a different switch (membrane pad or slider)
They are labeled differently to avoid not getting what you want from Scenario Dreams
You can wire a 2-button Open Bolt to a 1-button slider switch and it will function 100%
~ P8nt
_______________________
Jai "P8ntbal4me" MenardComment
Comment