General Question about Pneumag

[Frizzle Fry]

I've got a pneu'd Micro with an X-valve, but I've got another project and need some info...

What should the output pressure from the LPR to the MSV2 and ram be (roughly) on a Pneumag with a classic valve?

*edit:
Obviously it depends on the setup, but I'm looking for a rough range (low to high).

[xero28]

I may be wrong, but I believe it's up around 60-70 PSI? Maybe even higher. Put an RT on/off in there and you can cut the pressure by almost half.

[Frizzle Fry]

I may be wrong, but I believe it's up around 60-70 PSI? Maybe even higher. Put an RT on/off in there and you can cut the pressure by almost half.

Hmmm... Well, my lips are sealed about the project, but for whatever reason I'd be looking at 50psi or more coming from my regulation system.