The earlier emags used the 0.728" pins prior to the change over to quad orings. They work fine, even with the quad oring. I've been using the 0.728" pin and quad oring for 10 years.
The sear assembly being out of tolerance will cause the sear to not trip properly in electric operation. If the plunger is too long, it won't pull the sear far enough to properly clear the bolt and will cause wear. If the plunger is too short, it won't have enough power to consistently pull the sear in all conditions, but could work fine as long as the battery is full and everything is working good. Proper lengths make everything work good consistently.
The sear assembly being out of tolerance will cause the sear to not trip properly in electric operation. If the plunger is too long, it won't pull the sear far enough to properly clear the bolt and will cause wear. If the plunger is too short, it won't have enough power to consistently pull the sear in all conditions, but could work fine as long as the battery is full and everything is working good. Proper lengths make everything work good consistently.
Comment