I was rearranging my lpr (rock) location on my gforce frame today with new hoses and barbs. While making sure all my connections were solid, I discovered 2 leaks in the msv-1. It's the brass part of the pneumatics. The pin that the trigger presses on has 2 small pressure release holes and the side one is constantly leaking. Also, the bigger screw on the back lets out air constantly too.
I'm kinda figuring that the back screw is adjustable and controls how far the front pin travels and is not letting it sit right. Before I go putting some elbow grease into this it would be nice to know if there is any wisdom on this issue, and how to fix it correctly.
Yes I did oil it up real good thinking I could seal the leaks with no luck.
I'm kinda figuring that the back screw is adjustable and controls how far the front pin travels and is not letting it sit right. Before I go putting some elbow grease into this it would be nice to know if there is any wisdom on this issue, and how to fix it correctly.
Yes I did oil it up real good thinking I could seal the leaks with no luck.
Comment