-
-
Try increasing your input pressure
-
Use a shorter rt pin. There could be a slight difference in assembly position between the retro assembly and the classic assembly with respect to the top of the assembly. If the retro assembly sits lower(farther out of the hole) it would require a shorter pin to fully open the valve. I have heard others having the same problem. It was fixed using a shorter pin.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Comment
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment