Could you charge an emag with...

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • leloup
    Mag Addicted
    • Feb 2009
    • 634
    #1

    Could you charge an emag with...

    Do you think it would be possible to charge an emag with a cordless drill charger? Maybe a pair of gator clips jumping the bridge. Any ideas? Any one try it?
    Tags: None
    • Newt
      Darth Amphibian
      • May 2009
      • 450
      #2
      Possible, sure. Probable? Not so much. You're really likely to be putting a very different amperage/voltage in than the battery is expecting.

        Comment

        • leloup
          Mag Addicted
          • Feb 2009
          • 634
          #3
          What are the amp/volts required for the battery?

            Comment

            • Tunaman
              Specialized AGD Tech

              • Dec 2000
              • 8643
              #4
              Just remember that there are NO MORE EMAG BOARDS. I dont recommend it.
              Email me for low prices on ALL AGD Products and more. [email protected]
              Tunamart

                Comment

                • leloup
                  Mag Addicted
                  • Feb 2009
                  • 634
                  #5
                  There is no way taht I would connect any power source to the board besides an AGD battery. But, I would connect the battery to something to charge it....

                  Success! I checked the volts and amps of the cordless drill charger, and they are slightly less, volt wise, and much less amps wise. I let it charge for about 45min, and now I have a good charge on my battery. It is an older battery, so I wasn't worried about damaging it (covered in rust from previous owner).

                    Comment

                    Previous template Next
                    Working...