Frustrated after a day of paintball

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • M98Punk
    NYOG President
    • Nov 2002
    • 656

    #1

    Frustrated after a day of paintball


    SO I went to play today with 4 guns and none of them worked well my pistol did but the spacing is off on my feed for it so I was having issues. Anyways before I throw something against the wall my R/T valved micro was acting screwy today and after rebuilding most of the reg in the back of my Yaris I was still having it leak out the velocity adjuster in the back BUT when I would adjust the velocity up or down it would stop until I fired then it would leak again. So yeah I'm sure someone knows what it is and it is an easy fix but right now I am thinking investigation with a blowtorch and hammer so I will go have a brew and see what the AO crew in there infinite wisdom bring.


    Oh and if someone knows where to get old school bushmaster 2000 detent let me know

    and a nice cheap reg that will work with a bushmaster (even thou my brother swore a vigilante with a low pressure spring would work it would not for me)

    And that high pressure macroline that was being sold a few years back that still around?

    But I did rock the last game 2v3 with a mag pissing air so I had to literally turn my gun off in between moves . I got two eliminations and pushed the third guy into my teamates fire
    Girls are no substatute of paintball

    Murphy's law of paintball: If it jams force it. If it breaks it needed replacing anyways
  • Ando
    Magusmaximus
    • Jun 2009
    • 4144

    #2
    You need a new reg piston (the brass part in the back of the reg).
    My Feedback

    Comment

    • Coralis
      Hyper Micro
      • Aug 2005
      • 1285

      #3
      the ball detent for the bushmaster 2000 is a cocker one so you shouldn't have a problem finding one ... as far at the regs i don't know i'm still using the stock ones on my wife's bushmaster.

      Comment

      • athomas
        Of course it works-its AGD
        • Jan 2002
        • 8039

        #4
        Did you replace the oring on the regulator piston assembly and clean out the back section of the valve?

        If you are running a level 10 in the retro valve, and the regulator piston assembly hasn't been updated to a new higher pressure one, then that is probably what is causing your problems.
        Except for the Automag in front, its usually the man behind the equipment that counts.

        Comment

        • M98Punk
          NYOG President
          • Nov 2002
          • 656

          #5
          is that something i can ge tfrom tunaman?/
          Girls are no substatute of paintball

          Murphy's law of paintball: If it jams force it. If it breaks it needed replacing anyways

          Comment

          • Ando
            Magusmaximus
            • Jun 2009
            • 4144

            #6
            Yep. From him or AGD. There's a way to temp fix it. Go to BigEvil.com, in their tech forums, you should find a thread on how to temp repair the piston till your new one comes in.
            My Feedback

            Comment

            • theGOLDENchild
              Registered User
              • Jan 2009
              • 255

              #7
              You can also get the nice macroline from Tuna.

              Comment

              Working...