Xvalve full auto with trigger full pull

[shades]

I have an Xvlave on a mini mag body and rail that is firing full auto with trigger in full pull.
Running with a fixed reg. Tried changing the on/off with my other RTs with the same result. Is the on/off pin too short?
Any input would be apreciated.

[factoid]

I have an Xvlave on a mini mag body and rail that is firing full auto with trigger in full pull.
Running with a fixed reg. Tried changing the on/off with my other RTs with the same result. Is the on/off pin too short?
Any input would be apreciated.

If you swapped on/offs including the pin I doubt it's too short, unless you've done modifications to your on/off pins.

Check your sear, is it showing signs of wear? It might not be catching the bolt on the return.

[Newt]

The same on/off is having the problem with completely different valve/sear/bodies?

You might try an Emag quad oring.

[Ando]

Are all your on/off orings there #22 & 23?

That will cause it to go full

[maineiacpballer]

I had this problem and was missing #9...