X Valve issue

[VecTor]

I have 2 mag body setups. One is a standard agd (smart parts grey splashed setup)
the other is a pneumag setup (RT rail intelli pneu frame)

When I have my x-valve in the standard agd setup the valve shoots great.

The biggest problem is when I use my x-valve on my pneumag setup i get random bolt a lot which is very frustrating. The gun will not fire until i push on the bolt to re-seat it. What is it that i need to adjust to fix this??

I am currently using the spacer with 2 lines and no shims.

Thanks for the help.

[Ando]

Easiest thing to do first is swap out your bolt spring.

If that doesn't fix the problem you might be experiencing bolt stick. Go up another carrier size. Keep going up till it starts leaking then go back to the last one that wasn't leaking. Make sure you use the same white oring in the carrier while swapping them out.

[factoid]

Got any shims in your level 10? Try pulling those out.

[211]

check the tip of the sear on the pneumag setup and make sure it has a sharp edge
any kind of chipping or wear on the edge can cause severe bolt stick

[cadams]

same body on both setups, or different bodies?

[VecTor]

Thanks for the help and suggestions. I am going work on my mag this weekend.

I have agd ule main bodies on both setups (one black & one grey)

I have no shims in the power tube.