Can a Level 10 Bolt Fit in a .682 Barrel Back

[Ohms Law]

Paint just keeps getting smaller and smaller. My level 10 bolt fits in a .685 barrel back. Does anyone know if it will fit in a .682 or smaller? How small of a barrel bore will the level 10 bolt accept?

[factoid]

Paint just keeps getting smaller and smaller. My level 10 bolt fits in a .685 barrel back. Does anyone know if it will fit in a .682 or smaller? How small of a barrel bore will the level 10 bolt accept?

Twist-lock or cocker threaded?

Don't the cocker threaded bodies place the threads for the barrel in front of the bolt entirely? The breech is what the bolt will travel through and it stops just short of the bolt actually touching the barrel.

If it's a twist lock I can't be sure. I've only rarely seen a twist-lock smaller than .685, unless it's a python kit which goes down in the .675 range, but again I think that insert might sit forward of the bolt.

[TwilightG]

I've used a .675 freak insert w/o any problems

[Ando]

I've used a .675 freak insert w/o any problems

Agree...

[Frizzle Fry]

but again I think that insert might sit forward of the bolt.

Correct. The bolt doesn't actually enter the control bore; only the breech.