So my automag valve is leaking from the 2nd hole, the one towards the bolt. I know this is caused by the pin assembly into between the two halves. I've already tried oil, and cleaning the closer oring right behind the brass piece. No go, so I yanked the whole assembly out. Both of the orings are severly worn and falling apart. How do I change these? The black thing on the end of the assembly is in the way, I got the white piece in between them out already though since it has a split. Thanks!
-
-
Hey, you should be able to either just slip the o-rings on over the small black metal C-clip, (1st o-ring on, than the white teflon spacer with the slit on, and last 2nd o-ring on).
or you can even take the small metal C-clip off completely.
Just do it carefully so to not scrape/cut the new o-rings on the metal C-clip.
You might have to fight with it a bit, but it is a C-clip so it is flexible to a point enough to carefully allow you to take it off and put it back on without any damage.
Good luck hope this helps.
D.K. -
Ty very much, it did help. Got the orings changed out, and it stopped leaking. At least from that hole. See new thread. Ty.Comment
Comment