Lpr rating and egomag conversion question

[BenoitOWN]

The one in this picture? I have a 1200psi ninja reg'ed tank and I wanna make sure it can support it. I doesn't wanna blow up my tiny solenoid.

Also who does wire crimping(sp?) these day? Any electronic shop have some supply? And what connector it take for an etek star frame?

[hill160881]

Thats the LPR i had issues with. It caused my marker to have a shot every time i aired it up and when i degas it. I went with a palmer and problem solved. I think the max input pressure on those bullet regs is 850 psi.

It was not very accurate either. sometimes the noid would leak from to much pressure and others it would not even trip the sear. It could have been a bad reg but i don't know. I tried another small reg, i think it is a tickler. and it was the same as the bullet reg. I don't think they were meant to operate at these low pressures and air flows.

I do know this. The Palmer's reg was perfect from the start, adjust the pressure so it trips the sear and done.

I did this thread to show how i modified my etek frame and it is the same for a starframe. Only you dont need to dremmal out as mutch

http://www.automags.org/forums/showthread.php?t=254702

Another build thread i did with different information in it and more pics

http://www.automags.org/forums/showthread.php?t=253895

[BenoitOWN]

Im using Luke manifold w/ptp casing to hide the reg so I im not sure I can put a Palmer LPR in yet as im waiting on a body.

Thanks for the instruction but one thing is I don't have a etek noid plug. I only purchased a star frame upgrade

[p8ntbal4me]

I can make u some crimp fitting for the board. PM me about it.

As for the solenoid lord rating... u need to make sure you pressure from the lpr is not over the Max rated pressure for the solenoid. It matters not the pressure of the lpr.... only what pressure u run into the solenoid to get the performance u want.

So far... hill has been the only one to get a 20+bps from the S070 solenoid and not break it.

[hill160881]

I believe the noids fail because we run them at there max input pressure and any variation in the pressure the LPR puts out trashes the noid in a short time. It was an accident when i found out the Dragun LPR was so fast and accurate. Now if i could only find more of them.