Trying to rebuild a mag

[BIG BOB]

So I have been slowly trying to rebuild and old mag with an old rt valve and level 10. I just put an intelli frame on and aired it up and it seemed to just be blowing air out of the back of the reg in slow automatic bursts like it was trying to fire on rt but couldnt all the way. I have no idea where to even begin with fixing this. Thanks

[Ando]

Did it do this before the intel? Try turning down your velocity.

[athomas]

Either the pressure is turned up too high, or the regulator seat oring is leaking. You will probably need a new regulator piston assembly. The level 10 bolts operate at a higher chamber pressure than the level 7 bolts. That means the original piston assembly could leak out the back at normal operating pressures.