updating a classic, rebuild a classic rt

[thegrayghost]

1) i have a classic valved mag, double trigger.....can i purchase a proline auto response trigger and bolt right on and work? anything else have to be changed?

2) i bought the wrong valve, i believe, classic rt valve....what pieces and parts do i have to get to work with this valve, to make a marker work? or should i look for a classic rt already done, then sell the rt classic valve?

i have one complete classic mag...only spare parts i have are a single trigger frame off my classic mag, and the rt classic valve...

thank you

[Ando]

You'll spend more finding parts for the valve.

[athomas]

The RT classic valve is the only valve that is not interchangeable with any other mag valve. You'll notice that your RT valve is smaller in diameter than the classic automag valve and that the air input is on the bottom where the field strip screw goes. It only fits the classic RT mag body and classic RT mag rail.

The Proline auto-response trigger should bolt right on and work with your classic mag. There may be some minor adjustments that need to be done to the trigger rod for smooth operation.

[thegrayghost]

thank you for input....i think i will go with the proline............

[athomas]

The proline trigger frame has a stiffer pull, but all you need to do is pull and release 6 bps to shoot 12bps, which is insane for a mechanical marker. Be aware that some fields may not allow it to be used because of the ability to shoot two balls on each trigger cycle.