Flatline Help

[homer3dfx]

Ok i bought my new micro Emag yesterday at skyball then we head down too the local field to try it out then the one thing that has never failed me before starts leaking air on me. My flatline is leaking air out of the reg nut and the lp gauge is maxing out. I turned the reg nut right down and it still does it. So i clean it all out regreased it and oiled i don't know if that will work yet since i haven't any air to test it right now. I haven't changed the o-rings yet since the store was closed. Any idea's whats wrong? thanks

[homer3dfx]

i just tried too fill it up now its leaking out the fill nipple

[soilent green]

call AGD it sounds like a serious problem

[BlackVCG]

Your reg. seat probably went bad. Read my Flatline maintenance thread at the top of this forum. Replace that o-ring with one out of an RT parts kit and then try it again. If it's leaking out of the fill nipple, the check valve pin o-ring is dirty or it's not tight enough.

[homer3dfx]

thanks for the help i checked out the valve pin o-ring and its dead so i'll replace that when i buy the rt parts kit.