retro probs

[monkeyman5710]

i am new to the retro valve, when i fire it and hold the trigger it sounds like a a lawn sprinkler it is the on/off o-rings(same as on the classic valve)? if so do the teflon o-rings from a classic valve kit fit and will it solve the prob? any help will be great

[need4reebs]

on/off o-ring

so far thats what i did and its working! do you have a extra teflon o-ring to try out?

[monkeyman5710]

yeah i have loads of them lying around will have to try it out,

my trigger is very slow to return would this also say an on/off problem

[athomas]

If you get the lawn sprinkler when holding the trigger, then it is most likely the small on-off top oring. The white teflon oring from the classic valve is not the same as the urethane one from the retro valve. Use the retro valve urethane oring.

A leaking on-off could slow down the bolt return. the trigger can't return until the bolt has fully reset. Another cause of a slow trigger return is bolt stick due to a weak bolt spring. The bolt springs are a consumable item and should be replaced from time to time.

[need4reebs]

on/off o-ring

my mistake man! sorry bout that i am still new to the automags!