Older RT Slow Recharge

[cleviss]

I have a RT Automag with level 10. I sent it in for repair about 2.5 years ago the marker since then sat around in my closet and was not used. I recently got the itch to start playing again and got my tank hydro and purchased a new CP ASA and stainless steel lines for it. I opened up the gun oiled it up and aired it up no leaks gun fires fine at a slow pace but if I start to rapid fire the marker starts to spit and sputter on the third or forth shot. I thought my bottle regulator was bad so I just installed a Ninja High pressure reg on my tank putting out around 800 psi so my ASA gauge says. I am having the same problem it seems that the gun just doesn't want to air up fast enough the first two shots are great then the third is either slowing down or sputtering. I called Ninja they sounded that it was highly unlikely that it was a regulator issue more of a gun issue. I shot a short video of marker in operation see if this may help with my problem.

Thank you for your help

http://www.youtube.com/watch?v=fRCOHjX3a0I

[Enhander]

looks like your lvl 10 may need some tuning. That or you're not getting a full trigger pull, which is causing it to "short stroke"

[MANN]

you need more than 800 psi to rapid fire.

[cleviss]

I removed my original regulator that was putting out on my gage that was reading close to a 1000 psi output and getting the same results. My next move is that I want to tune my lvl 10. I just need to figure out how to do it. My main concern is watching my ASA gage pressure fall between shots and slowly come back to pressure. I know these gages are cheap and not reliable but any suggestions are appreciated.