removing twist lock assembly

[nathanjones008]

I think i have successfully removed thie twist lock assembly but the set screw is in the way if the ULE VERT body from laying flush with the rail. Is there something i am doing wrong? Thanks

[georgeyew]

I think i have successfully removed thie twist lock assembly but the set screw is in the way if the ULE VERT body from laying flush with the rail. Is there something i am doing wrong? Thanks

Set screw? Do you have a picture to show us?

[nathanjones008]

no pic

I am trying to put the pic on but no luck. But the set screw is what houses the twist lock assembly. It protrudes through the rail and goes into the trigger.

in the mean time i will try to get that picture up.


thanks

[nathanjones008]

here is a pic of twist lock assembly

http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=182&categoryID=90

[MANN]

hit the side with the allen head on something hard. Like a metal hammer. it will pop right out.

[pinkanese]

Did you just undo the screw and pull out the internals or did you push out the entire twist lock assembly?

[nathanjones008]

internals

all i did was remove the internals

[pinkanese]

You have to do like MANN said get a hammer and knock out the entire assembly for the body to fit.

[nathanjones008]

picture?

thanks.

Try this link to get a picture of what i am talking about. Hope this works

https://mail.google.com/mail/?shva=1#inbox/12f6b47c18e9ce21

Here is a better picture. As you can see the twist lock assemble is out but the set screw that houses the twist lock assembly is sticking out just enough where the Vert ule frame from setting flush with the rail.

https://mail.google.com/mail/?shva=1#inbox/12f6b532f6044f6f

[Tunaman]

If you BEAT it out you run the risk of bending the rail. It doesn't take much to wreck it either.
Do it right by supporting it properly and PRESSING it out.

[sjrtk]

Listen to Tuna. ^^^^^
I have a bent AM/MM rail to prove it.

[nathanjones008]

I got it to work! Thanks to everyone for the help! My mag project shall continue on!

[knownothingmags]

just as a big note.

iv done it already so dont haze me for it.
iv also paid for it by detistry.

dont use your teeth to hold metal steady while doing anything with it.
i twisted a chunk of one of my teath off by holding the twist lock assembly in my mouth and trying to loosen up the set screw in the bottom of it.

actualy haze away.

lol, just some info for all you learn by screwing upers.

thankyou,
knownothingmags.

[nathanjones008]

just as a big note.

iv done it already so dont haze me for it.
iv also paid for it by detistry.

dont use your teeth to hold metal steady while doing anything with it.
i twisted a chunk of one of my teath off by holding the twist lock assembly in my mouth and trying to loosen up the set screw in the bottom of it.

actualy haze away.

lol, just some info for all you learn by screwing upers.

thankyou,
knownothingmags.

WOW I hope you had dental coverage!