AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
I though just occurred to me. When using a warp feed with an Emag how does it work with Mech mode? Wouldn't you have to be in E or Hybrid to use a warp cable and connect it to the Emag's board.
Comment