Frame Question/ On/Off

[93klauss]

Can you run a automag CF frame on a emag rail? Using a am sear?

So the problem is, got am rail and emag body, not compatilble right now. When aired up I have pressure on triggger but it will not fire, hence last question about pin lenght. If it was a body interference I would not have the pressure or give on trigger. When I air the gun down and pull the trigger, the sear will hit the pin to let the valve slide out. So the sear is hitting the pin.

Pin too long? Using on off pin .728



Any other ideas?

[OPBN]

An AM/MM sear will not work in an E-mag rail. You need an RT Pro sear.

[93klauss]

An AM/MM sear will not work in an E-mag rail. You need an RT Pro sear.

Well thanks for clearing that up. Still


The problem is, got am rail and emag body, not compatilble right now. When aired up I have pressure on triggger but it will not fire, hence last question about pin lenght. If it was a body interference I would not have the pressure or give on trigger. When I air the gun down and pull the trigger, the sear will hit the pin to let the valve slide out. So the sear is hitting the pin.

Pin too long? Using on off pin .728



Any other ideas?