I haven't played paintball in a 3 or 4 years perhaps. I decided it was time to get back into it , so I dug out my old Mag. I had unfortunately only used it perhaps 4 times, and thus I know next to nothing about it.
When I gassed it up, it leaked continuously. The trigger pin is not popping forward behind the trigger most of the time when I gas it up. When it does, it doesn't pop back into place after the first shot and the gun leaks air nonstop. The on/off is a ULT kit. All of the O-rings appear to be in good shape, for whatever that is worth.
I think it has to be the on/off. It moves very easily with light finger pressure, but doesn't act right when I gas up the gun.
How should I start troubleshooting this? Do I need to replace all the O-rings in the entire x valve? I have ~1.5 weeks to get it done in time to play on my next weekend off from work.
When I gassed it up, it leaked continuously. The trigger pin is not popping forward behind the trigger most of the time when I gas it up. When it does, it doesn't pop back into place after the first shot and the gun leaks air nonstop. The on/off is a ULT kit. All of the O-rings appear to be in good shape, for whatever that is worth.
I think it has to be the on/off. It moves very easily with light finger pressure, but doesn't act right when I gas up the gun.
How should I start troubleshooting this? Do I need to replace all the O-rings in the entire x valve? I have ~1.5 weeks to get it done in time to play on my next weekend off from work.
.
Comment