Automag leaking

[Magmerc]

So I bought a 68 automag that supposedly worked. Ha. It appears to be leaking from the on off assembly. Sear length and on off pin length are correct. I think this is whats causing the leaks, is this the right assembly? I don't think so but may be wrong.

http://imageshack.us/photo/my-images/11/1010617o.jpg/

Pieces are (From left to right) the way they came out of the mag. Furthest left was all the way in. THERE ARE TWO ORINGS THAT ARE NOT PICTURED ON THE FAR LEFT.


Thanks.

[Coralis]

thats not a standard on/off assembly, its an aftermarket part called a reactor on/off. It goes in differently then a standard on/off does but i dont remember exactly how , also the orings look like they might need a change .

[Magmerc]

Awesome, I found out how it went in and I'll change the orings when I put it back in. Thank you for telling me that, I couldn't find any info on it since I didn't know what exactly it was.

[aerosaaber]

don't forget to oil 'er up good.

[Magmerc]

I will, just can't tonight. When I assembled the on off, it held air, so I test fired 10 shots. Fired great, but the point is if I shoot anymore at 10 30 pm I'll just be helping the whole paintball is bad thing when the cops show up. Ty.

[aerosaaber]

avoid handcuffs tonight, add oil tomorrow.