Power Tube Spacer? Or somthing else...?

[BIGJON]

Hey everyone. My Mag has a leaking problom. Ive replaced every o ring in the gun literally. When I shoot Rapidly, Somtimes ill get a leaking out the barrel. Then if i stop and fire it will usually go away. Im almost posative my spacer is to big or to small. I got my gun from ebay and i dont have any other spacers. Im going to go out and buy a spacer Kit but i want to make sure thats wut my problom is. And My spacer size right now is .225. So i dunno if it is to big or to small or not. what size should i try if i buy a kit. Mainly smaller or Bigger. Thanx

[Butterfingers]

Need more info.

If you put light pressure on the trigger and it hisses before firing you need a smaller spacer.

If you are shooting and it all of the sudden stops shooting and the trigger gets stuck back you need a larger spacer

[Predater]

sounds like short stroking to me. i have that happen now and again when i use my 68mag and not my rt.

[BIGJON]

yeah

Yes i put light pressure on the trigg and air comes out. thanx a bunch. +

[s-m-o-k-i-e]

i am having the same problem but if i hold the trigger down after i fire it will make a series of pops like it is releasing small amounts air could anyone tell me if the power tube spacers will help this problem?

[Butterfingers]

go into more detail about these "series of pops"

[s-m-o-k-i-e]

well it sounds kind of like a clock ticking (prolly two per sec.) only it is short burst of air i have looked and the bolt is not moving so i can not figure it out.

[Butterfingers]

My best guess it that it has somthing to do with your on/off I would check and replace the top on/off o ring and see if that helps.

[Butterfingers]

Is this the classic valve or an RT. If it is the classic valve replace the teflon o ring in the bottom of the on/off chamber.

If it is an RT valve replace the urethane 0-ring in the bottom of the on/off chamber.

[Jimmi9999]

i had this problem too

I had the popping noise or farting noise. turned out it was the reg seat and pin, try checking the spring too i had too stretch mine out so it wasn't compacted.

[leerix]

if you are running c02 your on/off pin might be sticking...take it out and clean....try that

[s-m-o-k-i-e]

ok guys thanx i got it to stop i think it was the on/off valve teflon o-ring but i also replaced the reg seat.
thanx