Does This Hole Look Too Large ?

[Dover]

I own a stock RT Pro, like this

However upon looking at where the Field Strip Screw is inserted at the rear of the Intelliframe, the hole seems a little large...



is this for the old school RT Banjo Bolt, or is this just me ?

[Ando]

Your just missing the spacer. If you have an old carbon fiber grip, it should have one you can use. I used a Z-grip missing the bushing for a few years with out any issues.

[athomas]

It should be fine. The front screw will keep things lined up, front to back. If you have a chance, get a spacer in there to take up the slack to prevent any side to side movement that could cause the sear/trigger rod to bind.

[georgeyew]

I got a plastic spacer from a hardware place and used a dremmel to fit it into the frame hole. It worked like a charm.

[xero28]

It's not a missing bushing. The frame was drilled to be used in a classic RT which uses a larger banjo bolt back there. You can see that the aluminum is raw inside of the hole, so it was done aftermarket. I drilled an intelli for a classic RT a while back myself. Pro Team Products used to sell spacers that fit, but like it's been said, just get a small piece of plastic and cut it to fit and drill a hole for the field strip screw.

[Madmarx]

The spacer from a level 7 bolt will work too.

[crudeidol]

Hey, that's the one I sent you right? I'm Redivulpis from MCB.