Mag won't fire

[XrobX]

Sticking a washer or two on the pin should help then I would assume?

[athomas]

Its pim not pin.

You need to shorten the pim. The pim is bottoming out in the hole in the rail. This causes the body to not sit flat. When you overtighten the field strip screw, it pulls the valve tight in alignment with the rail, but because the body sits on the pim, it acts like a pivot and tilts the back of the body down towards the valve. This puts the body out of alignment with the valve and causes sticking issues with the bolt.

This may not be your problem, but it should be checked out.

[XrobX]

Ill definitely have to check it out. Thanks.

[XrobX]

im just gonna send this thing into AGD and have em work on it. Its really starting to piss me off. thanks for all the assistance.