Warpfeed to emag

[wixxxman]

Just looking for the right person to help.Does anyone running the same set up? I have a warpfeed and running with the emag 1.8 software.I have the looks like the headphone jack that links both togather.Does any one know if it hast to be program to the board or it might be a matter of moving the jumpers around.Right know when i plug the the warp in it just spins and doesn't stop.Just looking for some help thanks again guys

[OneSelfLost]

I run a warp fed Emag (Love it BTW).

That is definitely a jumper thing, check out the Warp feed manual:

http://www.airgundesignsusa.com/manual.shtml

You are going to want to move the jumper to the Positive terminal.

If I may make one suggestion, a 12V mod makes a WORLD of difference. They are easy to make but PM me if its easier for you, I made a slew of them.

[DannibusX]

The instructions show three jumper positions for the warp. The emag/xmag use the positive signal jumper, which should be the middle position on the warp board.