Does the DYE rotor fit the ULE body feedneck?

[nathanjones008]

Just wondering. I am close to buying a rotor and i want to make sure it will fit my stock ULE body :)


Thanks team

[DevilMan]

No... or at least the ones I have they do not. One of the worst things about any marker today is a feedneck that isn't a clamp of some kind. Where it's Mag, cocker, PM, DM, Blazer... anything... I don't get why a company can't put a clamping feedneck on something.

So I don't think any rotor will fit the stock ULE feedneck. Not a STOCK rotor anyway.

DM

[nathanjones008]

thanks

Thanks. I found a really great deal on a rotor but i wanna make sure it fits. Cause i just got a halo b loader from a friend and its too wide(in diameter) to fit my ule feed neck

What is a great loader around that price range that fits a ULE body? :)

Thanks

[Redic]

Thanks. I found a really great deal on a rotor but i wanna make sure it fits. Cause i just got a halo b loader from a friend and its too wide(in diameter) to fit my ule feed neck

What is a great loader around that price range that fits a ULE body? :)

Thanks

All you need do is shave off some plastic from the neck of the motor
That is what I did to mine and it fits very well

[ricco220273]

All you need do is shave off some plastic from the neck of the motor
That is what I did to mine and it fits very well

That's what I did with mine

[DevilMan]

Well if it's a good deal on the rotor get it... it's easy to get a clamping feed neck. I have plenty of guns and basically refuse to carve down the rotor to fit just one of them... Instead I put a feedneck on it that the rotor will fit into.

You can sand down or file down the feedtube on the rotor...

DM

[Boltaction]

Yeah, i'd just spend the $24 on ebay for a brand new CCM lowpro feedneck. Especially if your getting a good deal on the Rotor. Youll have a lower profile marker and the CCM necks just look better.


-SW

[nathanjones008]

Thanks

Thanks for all the help :) I will keep everyones ideas in mind.

[gmiller0]

Thanks for all the help :) I will keep everyones ideas in mind.

They are all correct... Change the feedneck if ya wanna run the Rotor... I use the Rotor and it is by far the best low profile high speed dependable loader that is cake to pop apart and clean and the batteries last FOREVER!! I actually just changed back to my powerfeed body cause I run a red dot scope on my gun now:) if the dots on you at 120 feet, it's stupid accurate:)

[nathanjones008]

thanks

Thanks team. I just picked up a rotor this week!. I ll pick up a feed neck soon.