UTB in an E-mag??

[OneSelfLost]

I am making my own board for an E-mag build. Nothing fantastic, just a quick and dirty board to get it up and running. However, since I suck at programming, I know I will be wanting a better board. I am currently looking at the UTB but seek more information.

Can the board withstand the 19.5V from the E-mag battery?

Can I connect the E-mag noid straight to the board or will I need to fashion a higher current-rated mosfet in there? (I don't know what transistor is on-board)

With the HES, I'd imagine just a 10kohm pull-up resistor on the signal out of the HES then just run it to the trigger signal wire? Also, connect the positive and negative to the 5v Out and gnd respectively (given).

Please excuse all the questions, just want to get them out of the way before I go ahead and order one.

Any info would be great.

Thank you.

[correia3]

Contact p8ntbal4me. He should be able to help...

[211]

I installed a UTB in my lowers, worked awesome
you will need the capacitor for the noid, and Damon at scenario dreams said the voltage wont be an issue as long as you run a dwell lower than 30 ms
mines been running strong for 2 years now