Hy guys,
I ordered a set of replacement o-rings for my X-Valve (Tac One bought used) and took apart the valve, trying to replace them (as it was pretty bad in there, and I have no idea if previous owner ever changed any). However, I tore one the the larger o-rings trying to get it on (not to mention I wasn't completely sure which was which), and was having a supremely hard time trying to get some of the others off.
Rather than wait 2 weeks and spend $20-$30 on another package of o-rings (live in Canada), I figure when I have money again (University student), I will just send the valve to AGD to rebuild with the parts I have, plus a couple others.
My question is, has anyone ever sent in their valve for a rebuild, and how much did it cost? Did they (or will they) tune it for you to save you some time?
Thanks!
Also, I emailed Tuna through Tunamart as was recommended to me, but he hasn't replied yet about how much he would charge for this service.
I ordered a set of replacement o-rings for my X-Valve (Tac One bought used) and took apart the valve, trying to replace them (as it was pretty bad in there, and I have no idea if previous owner ever changed any). However, I tore one the the larger o-rings trying to get it on (not to mention I wasn't completely sure which was which), and was having a supremely hard time trying to get some of the others off.
Rather than wait 2 weeks and spend $20-$30 on another package of o-rings (live in Canada), I figure when I have money again (University student), I will just send the valve to AGD to rebuild with the parts I have, plus a couple others.
My question is, has anyone ever sent in their valve for a rebuild, and how much did it cost? Did they (or will they) tune it for you to save you some time?
Thanks!
Also, I emailed Tuna through Tunamart as was recommended to me, but he hasn't replied yet about how much he would charge for this service.
Comment