New Problem Classic Valve

[pwidby]

Ok, I have a new problem. I have a classic valve w/ a Dye grip frame running off 3000psi tank. First I could not get the gun to fire and there was a lot of pressure on the trigger. So I adjusted the trigger rod and now when I pull trigger it goes full auto. Maybe power tube o ring?
Thanks, Paul

[OneSelfLost]

I had a valve full auto due to an on/off o-ring, check the top two on/off orings. Keep a few mm gap between the back of the trigger and the trigger rod. Lube lube lube, mags love lube.

[athomas]

The powertube oring shouldn't cause a full auto problem. That is usually caused by a leaking on-off top oring. It is usually the small white teflon oring that needs to be replaced.

The trigger rod should be adjusted so that there is a tiny gap between the front of the rod and the back of the trigger when you hold the trigger against the safety stop when the valve is aired up.