So I have a mag with retro valve... it is double firing.. one when i pull the trigger than another when i release.. i just replace all the orings so i am not sure why it is doing this.. not sure if it had something to do with me shaving the on/off pin down a little bit.. ideas?
-
-
Check your sear. It doesn't look like much ware on the tip but it happens. also take a look at the lip on the bolt. -
How much did you shave the pin? What is its length now? If it is the pin, try installing a quad oring in place of the on-off top oring. Heck, do it any way. It makes the trigger action smoother, but it does alter the sealing point to a point farther out on the valve. It will simulate a longer pin.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
Comment