Mag double shooting

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • M600
    Registered User
    • May 2010
    • 27
    #1

    Mag double shooting

    ok my mag just recently started double shooting, ie one shot when the trigger is pulled back, and one shot when the trigger is released
    after a few shots it just leaks down the barrel
    replaced the black on off oring and messed about with the level 10 with no luck...
    its got an xvalve on a classic rail, spring had all of 1000 shots and tested it with a new one
    heres a video
    http://www.youtube.com/watch?v=F_T_d4D40Gs

    (reg is not attached)

    any help appreciated
    Tags: None
    • redlaser666
      US ARMY SGT
      • Jul 2002
      • 841
      #2
      Originally posted by M600
      ok my mag just recently started double shooting, ie one shot when the trigger is pulled back, and one shot when the trigger is released
      after a few shots it just leaks down the barrel
      replaced the black on off oring and messed about with the level 10 with no luck...
      its got an xvalve on a classic rail, spring had all of 1000 shots and tested it with a new one
      heres a video
      http://www.youtube.com/watch?v=F_T_d4D40Gs

      (reg is not attached)

      any help appreciated
      Could be a worn sear, sounds leke when you release the trigger the/on off is opening to allow air in to the bolt chamber, but the sear isnt catching well enough to hold the bolt back.

      Check the sear and bolt for unusual wear or chipping.
      My FeedBack

        Comment

        • M600
          Registered User
          • May 2010
          • 27
          #3
          the sear works fine on my classic valve... but ill try a new one just in case
          also im making an electro mag project, what are the advantages of using an EP set up compared with a spyder/clicker solenoid?
          cheers
          Marek

            Comment

            • redlaser666
              US ARMY SGT
              • Jul 2002
              • 841
              #4
              The spyder noids sometimes work, sometimes dont. Depends on the board you plan on using. If you use a standard spyder board the time the solenoid is ON may not be enough to actuate an automag properly. If you have a board that has adjustable dwell then its easier to work around.

              The EP has the advantage of being able to start as a mech pneumag and later just change the msv valve for a soleniod and board.
              My FeedBack

                Comment

                • M600
                  Registered User
                  • May 2010
                  • 27
                  #5
                  well im going to use an slg board which has adjustable dwell so hopefully it will work, will i need a ult kit?

                    Comment

                    • redlaser666
                      US ARMY SGT
                      • Jul 2002
                      • 841
                      #6
                      Standard RT on/off should work fine for EP, if using a clapper then I would go with the ULT on/off
                      My FeedBack

                        Comment

                        Previous template Next
                        Working...