So i have never run anything over a standard 850psi - ish regulator on any gun before. I got the Ninja SHP reg for my mag, which i must say is AWSOME. Only one macro line fitting leaks, the one on my on/off asa. im guessing because the pressure pushes it out with such force that any fitting would do this? should i swap to a stainless line for running a high pressure reg?
-
-
wiggle it a bit once it is aired up, it should quit. That is what mine do anyway.Fire power my friends. -
i tried messin with it. i just didnt try a new fitting because 1100 psi is some pretty good pressure... sometimes it would leak for like 10 seconds and then die off and stop, other times it would be a slight leak you could only hear off the field.Comment
-
Those fittings have orings inside which are replaceable. You could have dirt/grime underneath the oring causing your leak or a bad oring all together. You also want to cut your line as straight as possible your you'll never get it sealed.Comment
-
Try fresh macro line too
The outside of the pipe sometimes gets scored when pulling in/out of fittings causing leaksComment
Comment