Race framed pneu-mag

[DarkApollo]

Finally got my pneu kit from Mag79 and instead of modifying my intelli frame I am using a spare Race frame to make an e/p mag.

It almost all fits, but not quite.




Need a place for the battery. Might gut a high pressure reg and stick the battery in there, or find a foregrip that has a 3/4" od or an emag front for the 09mm.
Also, the piston sticks up about 1/4" out of the frame. Need to make a custom searless on/off as well.

[xero28]

Just out of curiosity, why are you using such a large solenoid? You can get rid of about 75% of it by going with one of the smaller SMC noids that are commonly found in EP mags. Good luck with the project. I still regret selling my EGOMag.

[DarkApollo]

Just out of curiosity, why are you using such a large solenoid? You can get rid of about 75% of it by going with one of the smaller SMC noids that are commonly found in EP mags. Good luck with the project. I still regret selling my EGOMag.

Well, the Humphrey solenoid has a larger dump port so it will cycle faster, it uses the right molex for the race board, uses one input on the bottom and output on top so its easier to plumb the hoses, etc. Plus I already have it so why not use it. The race battery would be in the same space, but thats easier to relocate.