automag not recocking

[jakethesnake0329]

I have been reading through forums and websites all night and have tried alot of the solutions and no luck

Marker- AGD tac1
Issue- not recocking all the way (fires first shot and i have to manually push the bolt back the last 1/4 of the way to stop air from leaking down the barrel and reset the bolt)

things attemped-replaced various orings and adjusted pressure both up and down, also switched out bolt spring for a new spring

my question is, is this a common and is there a specific oring that would cause this problem, any and all help is much appreciated


little more info, i had the marker working and operation in march, then went on deployment and it sat for a extended amt of time, picked it up today and discovered this issue

[river031403]

does it have a lvl 10

sounds like a lvl 10 issue

[knownothingmags]

i would swap to a shorter spring.
or longer.

looks like your need a good old valve tune n smooth

[zondo]

What's the output pressure of the tank?

[jakethesnake0329]

not sure on output pressure of tank, i have tried 2 tanks 1 ninja and 1 cp, both cause the same issue

[jrod]

Make sure the field strip screw is not too tight. If you loosen it a little, that should help.

[Coralis]

sounds like you need to retune your level 10 .... you want the largest spacer that doesnt leak when the sear is engaged.

[athomas]

Yes, it sounds like a level 10 issue. You need to remove all the powertube shims and use the largest carrier size that does not produce a leak with your oring. Always use the same white powertube oring in your carrier. Its the oring that you are adjusting.