Trigger Rod Length

[El Zilcho]

Is there an easy way to adjust the trigger rod length without having to take the marker apart. I took the grips off of my intelli and it didn't seem like there was a way to get to the rod.

[Justus]

No. Don't over-think it. You just removed at least 2 screws (possibly 4) to take the grips off the Intelliframe. If you had instead removed the field strip screw and the front frame screw, you'd be done.

[El Zilcho]

Ha, I know but when I remove the field strip screw, it ends up being a hassle given there is a bit of tension in both of my macrolines. Also, the screw that goes through the trigger frame is starting to strip a bit. Oh well, guess I will just have to bite the paintball and take it all apart each time.

Thanks

[zondo]

If you have a set of calipers, should be this:
Trigger Rod: 1.985"

[El Zilcho]

Still Apply

If you have a set of calipers, should be this:
Trigger Rod: 1.985"

Would this length still be appropriate if I had Luke's sear mod done? I would guess yes but just want confirmation.

[BigEvil]

Would this length still be appropriate if I had Luke's sear mod done? I would guess yes but just want confirmation.

You need to ask Luke that one. The specs are the specs for a reason. However, with a little tinkering it shouldnt be hard to figure out where the rod should be since its most likely off just a little.

BTW, you have to take the marker apart.