CCM Tac1 feedneck

[barkingspider]

I wanted to purchase the CCM and wanted input of individuals who have experience with the gun. Narrowing it down to the "no rise" vs the 1.5" rise. Optimally, I wanted to keep it the lowest profile, but without having to mod my rotor. I've used the search and see that many have put the "no rise" on their tac1, but to my knowledge you have to cut some of the neck off to fit? Any words of advice and input would be greatly appreciated.

[OPBN]

Not sure on the rotor, but I know on the Halo if you want your loader to fit flush, you have to cut the neck down for the no-rise. Look into AKA feednecks. They are cheaper and a little taller so that if you do have to cut your feedneck, its only a small amount.

[Fatalis]

This is a unmodded rotor with a 1.5 CCM feedneck.

[Fox_mini]

I can assure you that it's not needed to cut the rotor I use the low rise on my tac one without any problem!

[maniacmechanic]

nice job

This is a unmodded rotor with a 1.5 CCM feedneck.

[barkingspider]

thank you all for your input and help, it's greatly appreciated!

[sQuidvision]

i use a no-rise with my rotors on 3 different mags and its perfect...

[OPBN]

Interesting, is the feedneck that much shorter than on a Halo?