Level 10 micro cd??

[athomas]

I started using the next larger carrier when i got it and it was leaking with the trigger unable to be pulled, any other suggestions?

What do you mean by "trigger unable to be pulled"? Is the trigger not reset (loose)? Or is the trigger stuck or stiff?

If the trigger is loose because it did not reset, then it isn't caused by a loose carrier. That is caused by a carrier that is too tight, or an on-off oring that is leaking.

How old is your sear? Is the rail bushing in place? Are all the shims out of the powertube?

[Mr. Sinister]

when i got it I was unable to pull the trigger becuase the sear wasnt pushed forward after being aired up. I got the rail and sear used but it doesn't look that bad. I am getting a tacone rail and rt sear soon, will that help the issue? it leaks until I let go of the trigger as of now. I'm using the longest spring, didn't come with Red one, and no shims in it. Thoughts/ comments?

[athomas]

when i got it I was unable to pull the trigger becuase the sear wasnt pushed forward after being aired up.

That is caused by bolt stick. The bolt isn't fully resetting which prevents the sear from rotating forward and pushing the trigger pin out. Bolt stick is almost always caused by a carrier that is too tight. But, there can be other issues such as a leaking on-off pin or regulator pin assembly oring that can cause input air to continue flowing into the front chamber which will also prevent the bolt from resetting.

it leaks until I let go of the trigger as of now.

So, it leaks when you hold the trigger back but not when you release it? It usually doesn't work that way.