ReTro Valve Leak requestion

[frgood]

There is a small hole on the side of the RT Valve that is leaking. After watching the videos and ordering new rings, I replaced the prescribed Reg. Seat O-ring.

This did not repair the leak.

Is there a second point of failure for this leak?
Is this hole a pressure relief point?
Is it possible to install the Reg. Seat O-ring incorrectly (seems rather difficult to mess up)?

Thoughts would be appreciated.

[OPBN]

Is it leaking from the hole in the valve (front) portion or the reg(rear) portion? If front portion, take the reg pin out and clean and relube.

[frgood]

Is it leaking from the hole in the valve (front) portion or the reg(rear) portion? If front portion, take the reg pin out and clean and relube.

There is a small hole to the left (if looking from the rear) where the air is escaping.

[Ando]

Pull your reg pin assy out and ck the orings. If they're good then you probably have a speck of dirt or a piece of t-tape in the cavity causing the leak. Clean it out and you should be good

[frgood]

Pull your reg pin assy out and ck the orings. If they're good then you probably have a speck of dirt or a piece of t-tape in the cavity causing the leak. Clean it out and you should be good

Thanks I will do so this evening and report back