Flat line slow pressure

[mr.Jhon]

Hi I have a 3000 psi flatline set as 1100psi that is slowly leaking

-turning psi down will shut off small leak
-turning psi at and above 1100psi will increase small leak
-shooting 1-2 shots makes the pressure drop and take 5-6 sec to climb back up to selected psi and start slow leak again.

what would need to be done ?

-cleaning lubing, change internals or else ?

BTW is it possible to order from AGD a 4500 psi internal kit and upgrade ? I left a message to Dave's attention at AGD last week but haven't receive a answer yet probably busy

anyone have a opinion ?

jh

[Dayspring]

No - as your tank is a 3000 tank. You'd need a new bottle to handle the pressure. Secondly, the 3k Flatline and the 4.5k Flatline regs do not use the same parts. Can't just toss parts in.

[Spider-TW]

There's really only two working o-rings in them. Is AGD out of the 3k kits? They are standard 90 duro urethane o-rings, but I haven't tried to buy one or two in a while. You only have to degass the bottle to pull the top off; you don't have to take the whole reg off the bottle.

Here's a nice guide...

http://www.mcarterbrown.com/forums/a...6k-beware.html

This too...

http://www.warpig.com/paintball/technical/regulators/flatline/index.shtml

[mr.Jhon]

tks

thanks for the answers guys I now have a better idea how to clean and lube this machine maybe it will solve the slow pressure after a shot or two

jh